|
|
Post by MattH on Feb 9, 2007 21:13:27 GMT 12
I have gone from a HEI ignition back to a twin point dizzy and separate coil setup, but can't remember how to do the wiring and where the coil,ballast resistor, dizzy all fit together.  Maybe some1 can show their artistic skills and draw up a basic diagram? |
|
mat
New Member
Posts: 21
|
Post by mat on Feb 10, 2007 15:39:25 GMT 12
1. Wire from dizzy and condensor goes to negative terminal on coil
2. ignuition feed from switch goes to one side of ballast resister (dosent matter which way around the resister is)
3. Other side of resister goes to positive side of coil
4. Wire from start push button etc goes directly to positive side of coil
How this works is when starting car coil gets full 12v but when start button is released coil is supplied through ballast at about 9v hense a 9v coil must be ued with a ballast resister
|
|
